Universities, Colleges & Large Schools · Metro Atlanta, GA

Full HVAC Duct Cleaning & Microbial Decontamination for Universities, Colleges & Large Schools | Certified HVAC Hygiene & Compliance

Regulatory compliance, operational continuity and verified air quality — delivered with zero disruption to your campuses operation in Metro Atlanta, GA. Certified crews, engineered containment, and a documented report at handover.

  • IICRC-certified standards
  • Certified biohazard technicians
  • 24/7 rapid emergency response
  • Video inspection included
Commercial Air Care service van staged outside an Atlanta facility

Free site assessment

Tell us about your facility

Or call 404-999-3582 — we answer commercial calls during business hours.

Risks and compliance drivers in universities, colleges & large schools

Campuses in Metro Atlanta, GA share a specific set of failure modes in their HVAC systems. Below are the four we are called about most, and the standards that govern how each one has to be corrected and documented.

Classroom IAQ complaints

Staff and parent complaints about dust and odor escalate fast and publicly.

Aging unit ventilators

Decades-old univents and rooftop units hold heavy loading at the coil and cabinet.

Humidity and mold in gyms and locker rooms

High-moisture spaces grow visible microbial colonies at diffusers.

Short shutdown windows

All meaningful work has to fit into breaks and summer.

Standards applied on Universities, Colleges & Large Schools projects
StandardHow it applies
IICRC-certified source removalDocumented source removal across univents, AHUs and duct runs.
ASHRAE 62.1Classroom ventilation rates and outdoor-air verification.
EPA IAQ Tools for SchoolsFramework for assessing and documenting school indoor air quality.
OSHA 1910Technician safety controls in and around occupied campus buildings.

What duct cleaning & decontamination includes

Complete source-removal cleaning of supply, return and trunk lines, air handlers, coils and drain pans, finished with EPA-registered antimicrobial treatment.

  • HEPA vacuum extraction on every accessible run
  • Coil, blower, plenum and drain pan cleaning
  • EPA-registered antimicrobial application with logged dwell time
  • Before/after camera footage per zone

Our five-step field process

Every project follows the same sequence, whether it is one air handler or a full campus. Each step produces evidence that ends up in your handover report.

  1. Fiber-optic & robotic camera inspection

    Every system is filmed before a brush touches it. The baseline footage sets the scope, identifies damage and closed dampers, and becomes the first half of your before/after record.

  2. Negative pressure containment & HEPA filtration

    Work zones are isolated and held under negative pressure with HEPA-filtered machines, so debris leaves through the equipment instead of into the occupied building.

  3. Mechanical agitation, brushing & vacuum extraction

    Rotary brushes, air whips and compressed-air tools release bonded debris while the vacuum holds continuous capture — source removal, not surface dusting.

  4. EPA-registered antimicrobial disinfection

    Once the system is physically clean, labeled antimicrobial chemistry is applied to duct interiors, coils and pans, with product, dilution and dwell time logged.

  5. Air quality audit & compliance report

    Post-clean camera footage, airflow readings and particle counts are compiled into one report with technician credentials, standards applied and a floor-plan reference.

Campuses FAQ

Can the whole campus be done in one summer?

Usually it is phased. We baseline every building, rank by condition and complaint history, then schedule the worst buildings first and carry the rest into the next break with a written multi-year plan.

What can we show parents and the board?

A per-building report with before/after imagery, the systems cleaned, the standards applied and post-clean airflow readings — written to be read by non-technical stakeholders.

How long does a full decontamination take?

A single air handler and its branch runs is typically one shift. Full-building programs are scoped per system so you get a phase-by-phase schedule before mobilization rather than an open-ended project.

How often should a commercial system be cleaned?

Most commercial systems fall in a three to five year cycle. High-occupancy, high-dust or high-moisture facilities move to annual or biannual intervals — we set the interval from the baseline inspection, not a sales rule.

Do you work nights, weekends and shutdowns?

Yes. Most commercial work in Metro Atlanta runs outside normal operating hours. We build the schedule around your occupancy and hand each area back clean and ready for use before your team returns.

Schedule a free campuses site assessment in Atlanta.