Deviation exposure
Visible duct debris found during an audit turns into a written deviation and a CAPA.
Pharmaceutical Manufacturing Facilities · Metro Atlanta, GA
Full HVAC Duct Cleaning & Microbial Decontamination for Pharmaceutical Manufacturing Facilities | Certified HVAC Hygiene & Compliance
Regulatory compliance, operational continuity and verified air quality — delivered with zero disruption to your pharma plants operation in Metro Atlanta, GA. Certified crews, engineered containment, and a documented report at handover.
- IICRC-certified standards
- Certified biohazard technicians
- 24/7 rapid emergency response
- Video inspection included
Risks and compliance drivers in pharmaceutical manufacturing facilities
Pharma plants in Metro Atlanta, GA share a specific set of failure modes in their HVAC systems. Below are the four we are called about most, and the standards that govern how each one has to be corrected and documented.
Product cross-contamination
Shared air paths between suites move active ingredient dust where it does not belong.
Change-control friction
Work that is not documented in advance stalls at the quality gate.
Shutdown windows are short
Cleaning must finish inside a planned turnaround, not extend it.
| Standard | How it applies |
|---|---|
| IICRC-certified source removal | Documented source removal and post-clean verification. |
| ASHRAE 62.1 | Ventilation performance for manufacturing and support areas. |
| EPA-registered chemistry | Only labeled antimicrobials, with SDS and application logs supplied. |
| OSHA 1910 | Lockout/tagout, confined space and PPE compliance throughout. |
What duct cleaning & decontamination includes
Complete source-removal cleaning of supply, return and trunk lines, air handlers, coils and drain pans, finished with EPA-registered antimicrobial treatment.
- HEPA vacuum extraction on every accessible run
- Coil, blower, plenum and drain pan cleaning
- EPA-registered antimicrobial application with logged dwell time
- Before/after camera footage per zone
Our five-step field process
Every project follows the same sequence, whether it is one air handler or a full campus. Each step produces evidence that ends up in your handover report.
Fiber-optic & robotic camera inspection
Every system is filmed before a brush touches it. The baseline footage sets the scope, identifies damage and closed dampers, and becomes the first half of your before/after record.
Negative pressure containment & HEPA filtration
Work zones are isolated and held under negative pressure with HEPA-filtered machines, so debris leaves through the equipment instead of into the occupied building.
Mechanical agitation, brushing & vacuum extraction
Rotary brushes, air whips and compressed-air tools release bonded debris while the vacuum holds continuous capture — source removal, not surface dusting.
EPA-registered antimicrobial disinfection
Once the system is physically clean, labeled antimicrobial chemistry is applied to duct interiors, coils and pans, with product, dilution and dwell time logged.
Air quality audit & compliance report
Post-clean camera footage, airflow readings and particle counts are compiled into one report with technician credentials, standards applied and a floor-plan reference.
Pharma plants FAQ
Can you work inside a validated GMP environment?
Yes. We supply the protocol, materials list, SDS sheets and technician credentials ahead of time so your quality group can raise change control, then work to that approved protocol with sign-off at each step.
What happens if we find contamination mid-project?
Work stops in that zone, containment is extended, and we document the finding with photographs and location data before remediation continues. You get the finding in writing the same shift.
How long does a full decontamination take?
A single air handler and its branch runs is typically one shift. Full-building programs are scoped per system so you get a phase-by-phase schedule before mobilization rather than an open-ended project.
How often should a commercial system be cleaned?
Most commercial systems fall in a three to five year cycle. High-occupancy, high-dust or high-moisture facilities move to annual or biannual intervals — we set the interval from the baseline inspection, not a sales rule.
Do you work nights, weekends and shutdowns?
Yes. Most commercial work in Metro Atlanta runs outside normal operating hours. We build the schedule around your occupancy and hand each area back clean and ready for use before your team returns.
More services for pharma plants
Duct Cleaning & Decontamination in other sectors
- Duct Cleaning & Decontamination for Hospitals
- Duct Cleaning & Decontamination for Cleanrooms & labs
- Duct Cleaning & Decontamination for Industrial plants
- Duct Cleaning & Decontamination for Food processing
- Duct Cleaning & Decontamination for Senior living
- Duct Cleaning & Decontamination for Office towers
- Duct Cleaning & Decontamination for Hotels
- Duct Cleaning & Decontamination for Campuses
- Duct Cleaning & Decontamination for Data centers