Combustible dust accumulation
Process dust inside ductwork and on horizontal surfaces is both a fire and a deflagration hazard.
Industrial & Heavy Manufacturing Plants · Metro Atlanta, GA
IAQ Testing, Disinfection & Sick Building Syndrome Elimination for Industrial & Heavy Manufacturing Plants | Certified HVAC Hygiene & Compliance
Regulatory compliance, operational continuity and verified air quality — delivered with zero disruption to your industrial plants operation in Metro Atlanta, GA. Certified crews, engineered containment, and a documented report at handover.
- IICRC-certified standards
- Certified biohazard technicians
- 24/7 rapid emergency response
- Video inspection included
Risks and compliance drivers in industrial & heavy manufacturing plants
Industrial plants in Metro Atlanta, GA share a specific set of failure modes in their HVAC systems. Below are the four we are called about most, and the standards that govern how each one has to be corrected and documented.
Airflow loss across the floor
Loaded systems starve the plant of makeup air and drive heat complaints and fan overload.
Production cannot stop
Any work must fit between shifts or into a scheduled outage.
Insurance and audit pressure
Carriers increasingly ask for dated cleaning records on exhaust and makeup-air systems.
| Standard | How it applies |
|---|---|
| NFPA 652 / 91 | Combustible dust housekeeping and duct-system hazard control. |
| IICRC-certified source removal | Verified source removal across supply, return and exhaust. |
| OSHA 1910 | Hot work, confined space, LOTO and fall protection controls. |
| ASHRAE 62.1 | Ventilation baseline for occupied plant and office areas. |
What iaq & disinfection includes
Baseline indoor air quality testing, whole-system disinfection and a corrective plan that resolves sick building syndrome complaints at the source.
- Particle counts, CO2, temperature and relative humidity by zone
- Surface and air sampling where microbial growth is suspected
- System disinfection with EPA-registered chemistry
- Written corrective plan ranked by impact
Our five-step field process
Every project follows the same sequence, whether it is one air handler or a full campus. Each step produces evidence that ends up in your handover report.
Fiber-optic & robotic camera inspection
Every system is filmed before a brush touches it. The baseline footage sets the scope, identifies damage and closed dampers, and becomes the first half of your before/after record.
Negative pressure containment & HEPA filtration
Work zones are isolated and held under negative pressure with HEPA-filtered machines, so debris leaves through the equipment instead of into the occupied building.
Mechanical agitation, brushing & vacuum extraction
Rotary brushes, air whips and compressed-air tools release bonded debris while the vacuum holds continuous capture — source removal, not surface dusting.
EPA-registered antimicrobial disinfection
Once the system is physically clean, labeled antimicrobial chemistry is applied to duct interiors, coils and pans, with product, dilution and dwell time logged.
Air quality audit & compliance report
Post-clean camera footage, airflow readings and particle counts are compiled into one report with technician credentials, standards applied and a floor-plan reference.
Industrial plants FAQ
Can you clean around live production lines?
Yes. We stage by cell, isolate with containment, and schedule the loud extraction work into shift changes or planned outages so the line keeps running.
Do you handle combustible process dust?
We scope it explicitly: bonded and grounded vacuum equipment, no hot work in the zone, and removal sequenced so dust never becomes airborne in volume. Findings and quantities are documented.
Can testing tell us why staff are complaining?
Usually yes. Complaint patterns map to measurable causes — low outdoor air, high CO2, humidity above 60 percent, or particulate from a fouled system. We test by zone and report which of those is driving your complaints.
Is disinfection alone enough?
No. Disinfecting a loaded system is temporary. Physical source removal comes first, disinfection second, and the ventilation issue that allowed the problem gets named in the corrective plan.
Do you work nights, weekends and shutdowns?
Yes. Most commercial work in Metro Atlanta runs outside normal operating hours. We build the schedule around your occupancy and hand each area back clean and ready for use before your team returns.
More services for industrial plants
IAQ & Disinfection in other sectors
- IAQ & Disinfection for Hospitals
- IAQ & Disinfection for Cleanrooms & labs
- IAQ & Disinfection for Pharma plants
- IAQ & Disinfection for Food processing
- IAQ & Disinfection for Senior living
- IAQ & Disinfection for Office towers
- IAQ & Disinfection for Hotels
- IAQ & Disinfection for Campuses
- IAQ & Disinfection for Data centers